Transmission - Motorcycle construction

Motorcycle construction, Modern motorcycles normally have five or six forward gears. Only the largest touring motorcycles and a few models that are routinely used with a sidecar or converted to tricycle configuration are fitted with a reverse gear. On a few, including the Honda Gold Wing and BMW K1200LT, it is not really a reverse gear, but a feature of the starter motor which when reversed, performs the same function. The weight of these motorcycles, in excess of 360 kg (800 lbs), means that they cannot effectively be pushed backwards in some situations by a seated rider.

Older motorcycles had various kinds of shifting arrangements. A common version before World War II was a hand operated shift lever that rose from the transmission behind the engine up to beside the fuel tank on its left or right side. Later, some motorcycles, especially British, used foot shift levers that were located on the right side of the transmission. Today, shifting on the world's motorcycles has been standardized to the left-side foot-operated shift lever.

The clutch is typically an arrangement of plates stacked in alternating fashion, one geared on the inside to the engine and the next geared on the outside to the transmission input shaft. Whether wet (rotating in engine oil) or dry, the plates are squeezed together by a spring, causing friction build up between the plates until they rotate as a single unit, driving the transmission directly. A lever on the handlebar exploits mechanical advantage through a cable or hydraulic arrangement to release the clutch spring, allowing the engine to freewheel with respect to the transmission.

The most commonly used transmission is a sequential gearbox. From neutral, either first or second gear can be selected, but higher gears may only be accessed in order - it is not possible to shift from second gear to fourth gear without shifting through third gear. A five-speed of this configuration is commonly said to be "one down, four up," and a six-speed is said to be "one down, five up" due to the placement of the gears with relation to neutral. Neutral is considered to be "half a click" from first and second gears, so shifting directly between the two gears is made in one firm movement. Neutral is not placed "below" first gear to prevent the rider accidentally selecting neutral while attempting to downshift to first gear, possibly leading to an accident.

Scooters normally have a continuously variable transmission (CVT). The CVT is a type of automatic transmission (also occasionally used in cars) that can change the "gear ratio" (gears are not generally involved) to any one of the possible undetermined settings within a given range. The CVT is not constrained to a small number of gear ratios, such as the four to six forward ratios in typical automotive transmissions. CVTs are ideally suited to 2-wheeled vehicles because of the lack of shift shock. A conventional automatic transmission might shift shock at an unexpected moment and upset the vehicle. The CVT transmission also offers maximum power efficiency, an important factor for the engines with less than 100 cc capacity typically used in scooters.

sumber:http://en.wikipedia.org